Flare x Flare Needle Valve SAE

Flare x Flare Needle Valve SAE - Installation Parts Supply
Flare x Flare Needle Valve Brass, SAE

The Factory Installation Procedure is as follows:
  1. The handle nut should be checked for security.
  2. A dab of Petrol Gel to the O-Ring under handle nut is helpful in prolonging the life of the o-ring.
  3. The needle should be opened completely, then closed a couple of turns so the needle protrudes slightly beyond the orifice so as lime/scale builds up around the orifice the needle can poke through and close when needed.
If the final step is ignored, the valve may not operate properly after a very short time-depending on your water conditions-and is thus considered an installer error.

  • Click the part # in the list below for image, info and a closer look
  • Scroll down to bottom of page for more Info and Specs
  • 7-10 Day ETA for Out of Stock/Non-Stock Items in this Category
Products (Total Items: 2)
Sort by:

Part #






1/4" Flare Needle Valve Lead Free
In Stock.
3/8" Flare Needle Valve Brass
In Stock.
Browse By Brand
Browse By Category
New Releases
Top Sellers