Oetiker 15300004 5.1 - 6.1 mm / .201-.240 inch 1-Ear Oetiker Clamp Group 153, lowest prices, any quantity, full cases in stock, flat rate shipping, since 1995.

Master Distributor Since 1995
Genuine Oetiker Clamps
Stainless Steel, Material no. 1.4301/UNS S30400

Clamp diameter
The following applies as a guideline: To determine the correct clamp diameter, push the hose onto the attaching material, (e.g. the nipple), and then measure the outer diameter of the hose. The value of the outer diameter must be slightly above the average value of the diameter range of the clamp to be selected. The listed size of the clamp denotes the inner diameter (id) of the clamp.

How to Install
These clamps can be easily installed using Oetiker Hand Installation Pincers (HIP). The HIP tools have been designed especially for pinching ear clamps quickly and easily.
Oetiker HIP Compound Action, Standard Jaw Pincer, Item No. 14100386

Oetiker HIP Compound Action Side Jaw Pincer, Item No. 14100498

Oetiker HIP Single Action Standard Jaw Pincer, Item No. 14100396

How to Remove
Ear clamps can be easily removed using Oetiker’s hand clamp cutter (HCC). The HCC tool is designed to safely remove ear clamps.
Oetiker Hand Clamp Cutter, Item No. 14100519

Please Note: The clamps included in this category are not designed or intended for use in PEX applications. The sizing references for PEX clamps are not the same as standard Oetiker clamps. Oetiker PEX Clamps should be used for PEX applications.

Oetiker stepless clamp was invented by Hans Oetiker in Horgen, Switzerland, which eliminates steps or gaps on the inner circumference of the clamp. This is said to provide uniform compression and a 360° seal. Oetiker stepless clamps are well suited to applications involving thin-walled hoses, with higher retained loads. Oetiker Clamps are commonly used in the Automotive, Aviation, OHV, UTV, Marine, Beverage and Irrigation industries to name a few.