Watts Quick-Connect Series 35 products are designed and manufactured to be trouble free for many years of service life. Series 35 products are designed and manufactured in polysulfone, a high performance thermalplastic material. All Series 35 products are approved and certified to NSF-61-G, NSF 14, CSA B137.5, ASTM F877, and to the Uniform Plumbing Code (U. P. Code) and ASSE 1061.Series 35 products are available instandard imperial inch sizes. The Watts Quick-Connect design allows for quick and easy connections without installation tools. Simply cut the plastic, copper or CPVC tubing and snap a Watts Quick-Connect fittingin place for a zero leak connection. Watts Quick-Connect Series 35 fittings are designed for potable water systems. For other applications please refer to WATTS Technical Service Department.Tubing should be supported at minimum of 36" to prevent excessive load to the connectors. Do not install tubing supports closer than 3 inches from the connector ends. We strongly recommend that new installationsbe thoroughly tested prior to use. Do not use with explosive gases, petroleum products, or other fuels.
Material Specifications Series 35

Body: Polysulfone

Collet: Nylon

O-Ring: EPDM

Spacer: Acetal

Tube Liner: Polysulfone

Collet Clip: Delrin

CAUTION!!
The polysulfone material used in the Quick-Connect fittings can be compromised by exposure to volatile organic compounds (VOC’s) and caustic chemicals. Therefore, DO NOT expose this product to any such chemicalor foreign substance, which would include exposure to the following products: Pipe Dopes (thread sealants), bug sprays, lubricants, cleaners, paints, bleaches, acids, solder fluxes, plastic piping primers andcements, oxidizing agents, alkaline solutions, thinners, fuels, oil based caulks, hydrocarbons, spray foam of foaming agents (insulation). Watts recommends that all fittings and parts be stored in their originalpackaging until installation to protect the fitting internals from dirt and debris that may cause damage to the o-ring and the o-ring guide.It is also recommended that all threaded connections be made with Teflon tape only. Failure to follow these instructions will void the warranty and possibly result in leaks and water damage.

Fitting Performance Series 35 100psi @ 180ºF 250psi @ 75ºF

6.8 bar @ 82ºC 17.25 bar @ 24ºC

14-21 Day ETA for Out of Stock/Non-Stock Items in this Category

Thread Torque Values

Size Min. Torque Values Max. Torque Values
1⁄2"   17.7 in - lbs.            26.5 in - lbs.
3⁄4"   22.7 in - lbs.            31 in - lbs.